T3 S Kangertech

The Kanger T3S Clearomizer is a "Bottom Coil Changeable", you can easily change the coil every 10-15 fills, without having to change the Clearomizer entirely.

Kanger T3S power supply : the Coil is placed on the side of the battery to promote the arrival of liquid and the rendering of flavors.

Coil of 1.8Ω (+/- 0.2)

Kanger T3 Vs Kanger T3S : a better supply of e-liquid and resistance on the Kanger T3S for a rendering improved flavor! Smaller Coil, more reliable in use, and less expensive.


Filling the Kanger T3S Clearomizer:

• Unscrew the lower part which includes the base as well as the resistance Kanger T3S .
• Fill the reservoir with e-liquid by positioning the Kanger T3S upside down (drip tip / spout down) and run the liquid along the internal wall.
• Screw the lower base (which contains the resistance) back in without over tightening.
• Leave the Kanger T3S Clearomizer upright for about 3 minutes before starting to vape.

Advice : For an optimal rendering of flavors, we advise you to pump on your tip, from time to time, before vaping. Blow and suck several times (small breath) in your tip while activating your battery, and this quickly.

Changing the coil of the Kanger T3S:

• Unscrew the lower part (which includes the cap and the coil).
• Unscrew the resistance of the cap.
• Screw a new coil back onto the base ( red arrow ).
• Check that the gasket on the base is positioned flat ( blue arrow ).
• Fill the Kanger T3S with e-liquid and put the base (+ Coil) under the clearomizer.
• Leave your Kanger T3S upright for about 5 minutes.

Compatible with batteries (510 / eGo thread) : eGo T2, eGo C2, eGo C Twist, eVod, Vision, USB, Mods (with 510 / eGo adapter)…

Features Kanger T3S Clearomizer:

• Coil: 1.8 Ohms +/- 0.2
• Steam: warm, cold
• No screw: eGo
• Capacity: 3 ml
• Weight: 18.3 g
• Size: 79 mm
• Diameter: 14.5mm
• Coil life: 10 - 15 refills
• Drip tip: fixed
• Graduation: 3ml in two directions